Condition: used, Year of construction: 1975, max. wheel diameter 400 mm
gear width 0 mm
pinion diameter - max. 254 mm
axial cross angle 90 °
total power requirement 15 kW
weight of the machine ca. t
dimensions of the machine ca. m
G L E A S O N (USA)
Hypoid Spiral Bevel Gear Running Testing Machine
Model 513 TESTER, Year 1975, Serial No. 721607
This machine is very suitable for precision production testing of spiral and
hypoid bevel gears with shaft angle 90°. The gear spindle is vertical and
the pinion spindle is horizontal.
The pinion cone distance can be adjusted while the machine is working in
order to find the optimal mounting position whereby the gear is "loaded"
with a preset torque.
The axial pinion position can be adjusted until the quietest meshing position
of the traction flank is found. Likewise, the thrust flank can be tested
during the return run.
Marking compound is sprayed on both sides of the teeth so the flank contact
pattern can be seen. Working cycles, as well as the positioning in the
tooth gap, are automatic. The gear quality can be assessed by recording the
harmonic frequencies, which are displayed on a separate monitor and which
can be analyzed with a RHF Control. Machine can be used for soft testing of
production parts, as well as for mating sets of hardened gears and pinions
prior to lapping, and for final testing after lapping to select the optimum
pinion mounting distance. Also ideal for lab work, processing, and quality
Max. gear outside diameter, approx. 508 mm
Max. pinion outside diameter, approx. 254 mm
Axial cross angle 90 °
Offset of pinion spindle above/below gear spindle, max. 102 mm
Diameter of taper hole, pinion spindle 99/95 mm
Diameter of taper hole, gear spindle 56/55 mm
Speeds of pinion spindle, infinitely variable 0 - 1,250 rpm
Speeds of gear spindle, infinitely variable 0 - 1,250 rpm
Spindle drive, approx. 5 / 7.5 kW
Total electrical load, approx. 15 kW - 380 V - 50 Hz
Accessories / Special Features
* Large display for 1 / 2 / 3 harmonies, display for pinion distance,
pinion speed, as well of gear torque in kg/torque, etc.
* Hydraulic workpiece clamping. * Hydraulic slide clamping.
* Tank for marking compound with mixer and pump, separate.
* Separate switch cabinet. * Separate hydraulic unit.
* Lots of spare parts, spare motors, etc.
Condition : Good. Machine can soon be inspected under power.
Delivery : Ex stock, as inspected.
Payment : Net, after conclusion of contract.
Condition: refurbished (used), The Klingelnberg PKE140 bevel gear testing machine is designed for universal roll testing of bevel gears, face gears and gears.
Gears can be tested and evaluated here using a single-flank test.
The wheels are clamped using a threaded rod (spindle bore 30H4).
The device can be used to check the contact pattern, the center distance and the swivel angle can be adjusted using gauge blocks and a dial gauge.
The device is also suitable for 2-flank testing and backlash measurement, evaluation using a 0.01 dial gauge.
The drive is carried out by means of a hand wheel.
Maximum wheel diameter 140 mm
Installation dimension, maximum 90 mm
Adjustment angle, adjustable 50 - 140 degrees
Spindle Bore Wheel 30 H4
Spindle bore pinion MK4
Dial gauges Mitutoyo
The figure shows the machine in its current ACTUAL condition as a retrofit
Further information on possible options, purchase price and current status on request.
*Technical data and information are non-binding, subject to prior sale.