Lowbed

Fliegl VTS 400 P

Custom-tailored transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are customized according to customer specifications.

Further information
Chassis
Steel welded construction
Turntable with robust ball bearing, storage box recessed
Turntable extension
Foldable rear support
2 wheel chocks with holder
Aluminum side impact protection
Mud flaps at the rear across the entire width
Extendable wideners to 3,000 mm (not in rear slope)
(However, the track width of the construction machines or vehicles to be transported must not exceed the outer frame width of 2,550 mm)
Storage compartment for wooden planks in the center of the loading area
Wooden planks 70 mm for widening to 3000 mm
Tie-down eyes, low-loader type
3 pairs of tie-down points, each rated at 10 tons, integrated in the front of the floor
6 pairs of tie-down anchor plates, top and side in the outer frame, each rated at 10 tons
1 x in the neck area
the rest distributed in between with a maximum distance of 1200 mm
1 x rear slope
5 pairs of pocket slots recessed in the outer frame, inside 70 x 40 mm, (can be converted to 5-ton ring tie-down eyes, not included in the scope of supply)
Towing device, turntable trailer
Tow bar with tested 40 mm towing eye
Note! With a 40 mm towing eye, the permissible total weight of the truck must not exceed 18000 kg; otherwise, a 50 mm towing eye is required.
Axles + Suspension
SAF drum brake axles
Axle / chassis laser-aligned, reducing tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearing and mechanical axle load equalization in the front and rear (rocker equalization)
Wheels & Tires
235 / 75 R 17.5, according to manufacturer's choice
Steel rims in twin arrangement, factory silver
Braking System
2-line compressed air braking system
Spring-loaded parking brake
2 fail-safe coupling heads at the front, with connecting lines to the towing vehicle
ABS and ALB, with ABS plug at the front, with connecting cable
Attention: The trailer may only be pulled by towing vehicles which guarantee the effectiveness of the ABS!
Electrical System
24 Volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red side marker lights at the rear
2 x 7-pole fail-safe plugs at the front, with connecting cable
1 LED rotating beacon with holder, switched via parking light (beacon can be removed)
2 pairs of warning signs, double LED illuminated and extendable to 3,000 mm
Floor
Front area: steel floor
followed by 70 mm softwood floor, steel / diamond plate in the wheel arch area
Rear slope with 70 mm softwood floor
Access Ramps
Steel ramps, 2800 mm long, 750 mm wide, laterally movable
Fjdpfxji Ri I Eo Akkjgd
covered with wood
with gas spring support
Operating Instructions
With an axle load of 10,000 kg, an exemption permit is required, only indivisible loads are possible!!!
The stated total weight is technically possible; depending on the cargo, the total weight may not be reached while complying with the permissible axle / support and saddle loads.
Country of Registration / Signs
Country of Registration: Germany
1 with Dekra inspection and certificate (according to §13 EG - FGV)
24/7 service hotline
prepared for license plate holder, two-line
Contour marking with reflective strips according to ECE R 048, white on the sides and red at the rear
Paint finish
Frame: RAL 3002 Carmine Red
10-year warranty against rust-through
Tow bar: galv

The listing was translated automatically. Translation errors are possible.